lobiah.blogg.se -

#Garmin backup camera install manuals#
#Garmin backup camera install install#
#Garmin backup camera install drivers#
#Garmin backup camera install license#

#Garmin backup camera install license#

When installing the camera at the bottom of your license plate, you must remove, rotate, and reattach the camera clip. Out of the box, the camera mount is assembled for installing the camera at the top of your license plate. To allow for proper camera angle adjustment, the Garmin® logo on the camera clip must be right-side up when the mount is installed on your vehicle. Installing the Camera at the Bottom of Your License Plate

#Garmin backup camera install install#

Install license plate screws through the bottom holes of the license plate, and tighten (optional).This option is not available for all vehicles or for all mounting bracket positions.

Fully tighten the license plate screws.

Insert the license plate screws through the top of the license plate and mount, and into the license plate mounting holes on your vehicle.

It is your responsibility to follow license plate mounting regulations. Some jurisdictions prohibit covering any portion of the license plate. You must avoid covering any text or numbers on the license plate. You should use the mounting position that fits your vehicle and covers the smallest portion of the license plate.

Hold the license plate and mount up to the license plate area on your vehicle, and slide the mount up or down to align one set of mounting holes with the holes in the license plate.

If there is not enough room above the license plate on your vehicle, you can configure the mount for installation below the license plate (Installing the Camera at the Bottom of Your License Plate, page 1). NOTE: It is recommended to install the camera above the license plate, if possible. The flat metal plate on the bracket slides behind the license plate.

Slide the metal bracket over the top or bottom of the license plate.

NOTE: The camera mount is intended to be installed onto the bare license plate, and it is not compatible with vanity frames or license plate covers.

Remove the license plate screws from the rear of your vehicle, and remove the license plate, vanity frames, and license plate covers.

Installation Vehicle Mount Installation for North America Installing the Mount on Your Vehicle For questions specific to your vehicle, you should contact the vehicle manufacturer. These installation instructions do not apply to a specific vehicle type, and are meant as a guide when installing this product on your vehicle.

#Garmin backup camera install manuals#

You’ll need to mount the camera on the rear of your vehicle and connect it to a power source, such as the rear lights.24 Related Manuals / Resources BC™ 40 WIRELESS BACKUP CAMERA But if you’re a diehard do-it-yourselfer, that’s an OK alternative as well. Garmin recommends taking the BC 35 to your dealer for professional installation. The BC 35 is rugged enough to withstand even the harshest of weather. Up to 4 cameras can be used together in 1 system, for multiple viewing angles when reversing your vehicle.

#Garmin backup camera install drivers#

The onscreen guidance lines may be adjusted according to your vehicle size, to help drivers more easily gauge the reversing distance. As another option, you can wire the system to constant power, which allows you to toggle between the navigation display and backup display modes at the press of a button.

If the camera is wired to your reverse lights for power, your compatible Garmin navigator can automatically display camera footage every time the vehicle is shifted into reverse – and go back into navigation mode when shifted into a forward gear. When paired with a compatible GPS navigator, the BC 35 wireless backup camera is a multi-purpose Wi-Fi-enabled camera intended to help drivers easily spot vehicles, pedestrians, and other hard-to-see obstructions behind your vehicle. Compatible With the Garmin Overlander Take the Worry out of Backing Up